- For all porous materials and textiles.
- Also protects against oil, grease, dirt, pollution…
- For indoor and outdoor use.
- Colourlessly, odourless and safe.
NANOCARE PROTECT prevents the infiltration of dirt and moisture into porous materials and textiles. NANOCARE PROTECT protects against frost, slows discolouration due to UV radiation and works against moss and mould formation. NANOCARE PROTECT improves thermal insulation by 30% and makes woven fabrics more durable. NANOCARE PROTECT is ready for use, contains no solvents and is not flammable. One litre of NANOCARE PROTECT can treat a surface of between 2 and 10 m², depending on the porosity of the substrate.
Instructions for use
- Clean, rinse and dry the surface if necessary.
- Apply NANOCARE PROTECT in an upward motion, from bottom to top, in two successive coats, wet on wet.
- Allow to dry.
Apply with a brush or using a low-pressure pump fitted with a flat spray nozzle. The substrate’s temperature should be at least +5°C. Do not apply when it is raining or frosty. Make sure the work area is well ventilated and always wear a mask with type A filter during application. Dry in 24 hours, depending on substrate, temperature and amount applied. Maximum protection after 7 days. The equipment used can be directly cleaned with water. Immediately wipe off NANOCARE PROTECT from window panes or frames with a damp cloth.
Form: liquid. Odour: weak, characteristic. Melting point/Melting range: < 0°C. Boiling point/Boiling point range: > 100°C. Auto ignition: no. Explosion hazard: none. Vapour pressure at 20°C: approx. 23 hPa. Density at 20°C: approx. 1.07 g/cm³. Solubility in/Miscibility with water: complete. pH value at 20°C: ± 6 (and only apply on substrate with pH value between 6 and 13: so, after cleaning and before treatment with NANOCARE PROTECT, rinse and dry thoroughly). Shelf life: 6 months, dry, cool and frost free.
|Article number||Name||Package||Content||Unit||Category||Certificates and safety information|
Surface protection and treatment